JRH 625 Single bofor 1/96: Construction Guide

Construction guide:

1: There are 6 parts in the kit.
2: Drill the baseframe 0.5mm drill to take seats and trunnion wire handles.
3: Clean off the two front pads and rear pad of the baseframe to allow trunnion to sit squarely on the baseframe.
4: Jiggle the baseframe over the trunnion and glue in position using the three pads.
5: Fix the recoil cylinders to the barrel.
6 and 7: Glue the barrel assembly into trunnion with tail in chute.
8: Bend 28g of copper wire or similar (not provided) to this shape x2, for the handles.
9: Fix the handles into the trunnion where shown.