Construction notes:(Click on the thumbnail pictures above. Hover the mouse towards the top left or right of the picture when it opens, to move on to the next picture or back to the previous one.)1: There are 6 parts in the kit.2: Drill the baseframe 0.5mm drill to take seats and trunnion wire handles.3: Clean off the two front pads and rear pad of the baseframe to allow trunnion to sit squarely on the baseframe.4: Jiggle the baseframe over the trunnion and glue in position using the three pads.5: Fix the recoil cylinders to the barrel.6 and 7: Glue the barrel assembly into trunnion with tail in chute.8: Bend 28g of copper wire or similar (not provided) to this shape x2, for the handles.9: Fix the handles into the trunnion where shown.